Vermont Casting SR30SHK, SR24SHK, SR18SHK manual Installation Precautions

Models: SR24SHK SR30SHK SR18SHK

1 16
Download 16 pages 55.57 Kb
Page 2
Image 2
Installation Precautions

WARNING

Improper installation, adjustment, alteration, service or maintenance can cause injury or property damage. Read these directions thoroughly before installation. For assistance or additional information, consult your gas log dealer, qualified installer, service agency or gas supplier.

WARNING

WARNING

Do not use this appliance or any part that has been under water. Immediately call a qualified service technician to inspect the appliance and to replace any part of the control system and any gas control which has been under water.

If not installed, operated and maintained in accordance with the manufacturer’s instruc- tions, this product could expose you to sub- stances in fuel or fuel combustion which are known to the state of California to cause cancer, birth defects or other reproductive harm.

WARNING

A properly sized, unobstructed chimney will normally vent all fumes and products of combustion. Any odor or smoke detected in the room is an indication that the flue is not properly removing the combus- tion products. Turn off the gas supply valve immediately! The cause of the venting problem must be discovered and corrected before using this gas log set. Disregarding this warning can cause illness as well as soot damage to your fireplace, room and furnishings.

WARNING

Young children are not allowed to operate this unit and must be supervised when they are in the same room as the appliance.

Installation Precautions

Fireplace damper MUST be locked fully open when operating the gas log set.

If the fireplace has glass doors, operate gas log set only with doors fully opened. The fireplace screen must be in place when the appliance is operating and, unless other provisions for combustion air are provided, the screen shall have an opening(s) for introduction of combustion air.

The log set and its individual shut-off valve MUST be isolated from the gas supply piping system by closing its individual shut-off valve during any pressure testing of gas supply at test pressures equal to or less than 1/2 psig.

The log set and its individual shut-off valve MUST be disconnected from the gas supply piping system during any pressure testing of that system at test pressures in excess of 1/2 psig.

Keep the gas log set clear and free from combustible materials, gasoline and other flammable vapors and liquids.

2

3311956

Page 2
Image 2
Vermont Casting SR30SHK, SR24SHK, SR18SHK manual Installation Precautions