CONTROLFUNCTIONS
PROPANETANKVALVE
WARNING:
BURNERCONTROL VALVES
ACTIVATINGTHE IGNITER
ELECTRONICIGNITION SYSTEM
PIEZOIGNITION SYSTEM
Neveropen the Tank Valve unless the Grill is being prepared for use, to prevent the pooling of
propanevapor.
Alwaysopen the Valve immediately before lighting the Grill, and always close it immediately after cooking has
beencompleted.
(seeFig. 7)
On Models VCS3507, VCS3517 & VCS3507BI, there are three independent control valves for the main
burners,and a separate control valve for the rotisserie burner (if equipped).
On Models VCS4007, VCS4017, VCS4027, & VCS4037,there are four inde pendent control valvesfor the
mainburners, and a separate control valve for the rotisserie burner.
On Models VCS5007, VCS5017, VCS5027, VCS5037, & VCS5007BI, there are fiveinde pendent control
valvesfor the main burners, and a separate control valve for the rotisserie burner.
The OFF position is indicated above each knob.A full rang e of flame adjustment is available from High to
Low,(bytur ning a knob counterclockwise).
As you push and hold the Igniter Button, you will hear a series of clicks as the igniter module generates an
ignition spark to the burners. The burner should light within five seconds. Depending on which model you
have, the system is powered byeither a single “AA” or a single “AAA” battery. Ensure the battery has been
installed before using the igniter. To remove or replace the battery, turn the push button knob counter-
clockwise, and carefully pull out the spring and battery.Ensure that the positive end of the battery is in the
down(bottom) position before replacing the knob.
(if equipped)
Asyou turn the Igniter Knob clockwise, you will hear a click as the Piezo module generates an ignition spark to
theburner. Rotate the Igniter Knob until the burner lights. The burner should light within five seconds.
Page 6
(VCS5007Model Shown) Fig. 7
Igniter Button
(All Models)
Main Burners
(3, 4, or 5)
RotisserieBur ner Control
(if equipped)
Operation