VCS501 Series Assembly

Step 2a: Install the Casters

This step requires 2 people.

Parts Required:

(4)Casters (2 with brake, rear; 2 without brake, front)

(1)Block (not included)

(16)1/4-20 Flange Nut (30005406)

Figure 1

NOTE: Casters (wheels) may differ from those shown in the illustration depend- ing on the model you purchased.

Select a side to begin installing the casters. Place a block of wood, thick tele- phone book or anything else available - approximately 6 inches thick - under the side to support the weight of the barbecue. Insert the four (4) bolts attached on the casters into their respective holes located on the bottom, near the front. If you have any difficulty snapping them into place, try rotating the casters in a circular motion.

As one person holds the front caster in place, the other opens the front

door and installs four (4) flange nuts. Tighten the flange nuts on the front caster. Repeat this process with the rear caster.

When both casters are in place on one side, repeat the same procedure on the opposite side.

Rear Caster w/Brake

Blocking

Front Caster without Brake

Figure 1

B346

CAUTION: Some parts may have sharp edges; to avoid injury, wearing gloves during assembly, lifting or mov- ing the grill is recommended.

30005436

Page 3
Image 3
Vermont Casting VCS501 manual Install the Casters, Parts Required