Vermont Casting VCS501 manual Attach Skirt Optional, Figures 2

VCS501 Series Assembly

Step 2b: Attach Skirt (Optional)

Parts Required:		Leveling	Figure 2
(1)	Skirt Left Assembly	Glide
(1)	Skirt Right Assembly
(1)	Skirt Front Assembly
(2)	Skirt Corner Assemblies		Skirt Right Assembly
(7)	#10-24 x 1/2” Screws (50000337)	Skirt Left Assembly
(4) Adjustable Leveling Glide

Figures 2 & 3

Skirt Front Assembly B157

NOTE: Remove protective coating from corner posts before proceeding with this step.

Screw-in two (2) adjustable leveling glides into hex threaded insert provided in front skirt assembly.

Screw-in one (1) adjustable leveling glide into hex threaded insert provided in left and right skirt assem- blies.

Attach left skirt assembly to the unit:

–Loosen one hex bolt from corner post. (Refer to Corner Post Detail)

–Slide left skirt assembly between bottom panel and

side panel.

–Secure left skirt assembly with two (2) #10- 24 x 1/2” screws.

– Tighten hex bolt at the back of the unit.

Repeat these steps for right side.

NOTE: If you have any problems sliding the skirt assembly (left or right), loosen four (4) screws on side panel and lift the side panel to allow more space.

Slide two (2) skirt corner assemblies into the front skirt assembly. Slide above assembly into attached left and right skirt assemblies. Secure all skirt assembly parts with three (3) #10-24 x 1/2”

screws.

Loosen Outer Bolt

at Back Side

Corner Post/Skirt Detail	Skirt Left
	Assembly

Leveling

Glide

Inverted View

Figure 3

B347

#10-24 x 1/2” Screws

Skirt Front

Assembly

Skirt Corner Assembly

CAUTION: Some parts may have sharp edges; to avoid injury, wearing gloves during assembly, lifting or moving the grill is recommended.

30005436