MENU MODE

SIF SFT (SUB BAND IF SHIFT) GROUP

042 S-iF LSB SFT

Function: Sets the center frequency of the Sub band (VFO-

B)receiver’s IF filter in the LSB mode. Available Values: –1000 ~ +1000 Hz Default Setting: 0 Hz

043 S-iF USB SFT

Function: Sets the center frequency of the Sub band (VFO-

B)receiver’s IF filter in the USB mode. Available Values: –1000 ~ +1000 Hz Default Setting: 0 Hz

044 S-iF CWL SFT

Function: Sets the center frequency of the Sub band (VFO-

B)receiver’s IF filter in the CW (LSB) mode. Available Values: –1000 ~ +1000 Hz Default Setting: 0 Hz

045 S-iF CWU SFT

Function: Sets the center frequency of the Sub band (VFO-

B)receiver’s IF filter in the CW (USB) mode. Available Values: –1000 ~ +1000 Hz Default Setting: 0 Hz

046 S-iF RTTY

Function: Sets the center frequency of the Sub band (VFO-

B)receiver’s IF filter in the RTTY mode. Available Values: –1000 ~ +1000 Hz Default Setting: 0 Hz

047 S-iF RTTY-R

Function: Sets the center frequency of the Sub band (VFO-

B)receiver’s IF filter in the RTTY reverse mode. Available Values: –1000 ~ +1000 Hz Default Setting: 0 Hz

048 S-iF PKT-LSB

Function: Sets the center frequency of the Sub band (VFO-

B)receiver’s IF filter in the Packet (LSB) mode. Available Values: –1000 ~ +1000 Hz Default Setting: 0 Hz

049 S-iF PKT-USB

Function: Sets the center frequency of the Sub band (VFO-

B)receiver’s IF filter in the Packet (USB) mode. Available Values: –1000 ~ +1000 Hz Default Setting: 0 Hz

MODE-AM GROUP

050 A3E MICGAIN

Function: Sets the microphone gain for the AM mode.

Available Values: Ur/0 ~ 100

Default Setting: 30

When this menu is set to “Ur,” you may adjust the microphone gain using the front panel’s [MIC] knob.

051 A3E MIC SEL

Function: Selects the microphone to be used on the AM mode.

Available Values: Frnt/dAtA/PC

Default Setting: Frnt

Frnt: Selects the microphone connected to the front panel’s MIC jack while using the AM mode.

dAtA:Selects the microphone connected to pin 1 of the PACKET Jack while using the AM mode.

PC: This parameter is for future expansion of this transceiver’s capabilities, but at this time is not supported.

Page 116

FT-2000 OPERATING MANUAL