6.BASIC OPERATION

6.1PROHIBITED COMMUNICATIONS

The FCC prohibits the following communications:

yFalse distress or emergency messages:

yMessages to “any boat” except in emergencies and radio tests;

yMessages to or from a vessel on land;

yTransmission while on land;

yObscene, indecent, or profane language (potential fine of $10,000).

6.2INITIAL SETUP

1.Install the battery pack on the transceiver (see section “4.1.2 BATTERY INSTALLATION/REMOVAL”).

2.Install the antenna onto the transceiver; hold the bottom end of the an- tenna, the screw it onto the mating connector on the transceiver until it is snug. Do not over-tighten.

NOTE

Water resistance of the transceiver is assured only when the battery pack is attached to the transceiver and MIC/SP cap is installed in the MIC/SP jack.

6.3 RECEPTION

1.Press and hold the [POWER()] key for two seconds to turn the transceiver on. The DC supply voltage will be

indicated on the display for 2 seconds.

2. Press the [SQL] key to activate the squelch adjusting mode. Press the [T] key until the SQL level is “00”, then press the [SQL] key again (or wait 3 seconds to exit from the squelch adjusting mode). This state is known as “Squelch Off”.

3. Press the [VOL] key to activate the volume adjusting mode. Press the [T]/[S] key until the noise or audio from the speaker is at a comfortable level, then press the [VOL] key again (or wait 3 seconds to exit from the volume adjusting mode).

4. Press the [SQL] key, then press the [S] key until the random noise disappears. This state is known as the “Squelch Threshold”.

5. Press the [T] or [S] key to select the desired channel. Refer to the channel chart on page 42 for available chan- nels.

Page 20

 

HX760S