16

Software Menu Alignment

The ANT jack should be connected to a Dummy
Load (in the case of transmission) or RF Signal Gen-
erator (in the case of reception). General alignment
conditions are as follows, unless otherwise noted.
VOL Knob: Center (12 o’clock position).
SQL Knob: Fully counter-clockwise.
TX Output Power: HIGH
VOX:Off
The channel data in the radio is preset per the chart
below.
Press and hold in the keypad’s [1(MODE)],
[4(STEP)], [7(V/M)], and [F] keys simultaneously,
and turn on the radio while holding them in; the
alignment menu will then be activated.
In the alignment procedures, each alignment param-
eter is selected by pressing the [ALARM]/[2128] key.
Each alignment item is selected by rotating the CH
Knob. To store the alignment parameters when you
are satisfied with the adjustment, press the [F] key
for longer than a half second.
Note that a few alignment parameters are not ad-
justable, and are to be left as set at the factory.

TX OUTPUT POWER ALIGNMENT

Connect the 50 Ohm Dummy Load and Inline
Wattmeter to the ANT jack.
Referring to the Table below, press the [ALARM]/
[2128] key to recall each parameter listed, then
key the transmitter (connect pin 3 of the MIC jack
to GND) and rotate the CH knob for the required
output.
Channel
1-001
1-002
1-003
1-004
1-005
1-006
1-007
Frequency
1.7000 MHz
3.5000 MHz
5.5000 MHz
7.5000 MHz
12.0000 MHz
19.8000 MHz
29.0000 MHz
Alignment
Parameter
1PO-VH
1PO-H
1PO-MH
1PO-ML
1PO-L
2PO-VH
2PO-H
2PO-MH
2PO-ML
2PO-L
3PO-H
3PO-MH
3PO-ML
3PO-L
4PO-H
4PO-MH
4PO-ML
4PO-L
Output Power
125 W (± 5 W)
100 W (± 5 W)
50 W (± 5 W)
25 W (± 1 W)
10 W (± 1 W)
125 W (± 5 W)
100 W (± 5 W)
50 W (± 5 W)
25 W (± 1 W)
10 W (± 1 W)
100 W (± 5 W)
50 W (± 5 W)
25 W (± 1 W)
10 W (± 1 W)
100 W (± 5 W)
50 W (± 5 W)
25 W (± 1 W)
10 W (± 1 W)
Parameter
5PO-H
5PO-MH
5PO-ML
5PO-L
6PO-H
6PO-MH
6PO-ML
6PO-L
7PO-H
7PO-MH
7PO-ML
7PO-L
Output Power
100 W (± 5 W)
50 W (± 5 W)
25 W (± 1 W)
10 W (± 1 W)
100 W (± 5 W)
50 W (± 5 W)
25 W (± 1 W)
10 W (± 1 W)
100 W (± 5 W)
50 W (± 5 W)
25 W (± 1 W)
10 W (± 1 W)