Operating Manual Reprint

TOR button twice) to quiet the noise and resume normal (quiet) monitoring.

r To transmit, press and hold the PTT switch. Speak into the microphone area of the front panel grille (above the [D] key) in a normal voice level. To return to the Re-

ceive mode, release the PTT switch.

rPress the Soft key (if assigned to the Scan func- tion) or switch the TOGGLE Switch to the as-

signed “Scan” position (when so programmed by your dealer) to start the scanner. The scanner rap- idly steps through each of the dealer-pro- grammed channels, looking for incoming calls.

r Press the TOP SEL key

(on the top panel) or SIDE SEL key (the top

button on the left side) to a c t i v a t e o n e o f t h e preprogrammed func- tions which may have been enabled at the time of programming by the dealer. Similarly, when using the 16-key version, the [A], [B], [C], and [D] function keys activate one of these functions, if programmed by the dealer. See the next section for details regarding the available features.

r Switch the top panel’s TOGGLE switch to the

[A], [B] or [Center] position to activate one of the pre-programmed functions which may have been enabled at the time

of programming by the dealer. When this switch is in the [A (left)], [B (right)] or [Center] position, the feature programmed (by your dealer) to that switch position will be activated. See the next section for details regarding the available features.

rPress the DTMF keys on the telephone keypad while pressing the PTT switch to send DTMF

tones (16-key version only).

rIf a Speaker/Microphone is available, remove the plastic cap and its two mounting screws from the right side of the transceiver, then align the con- nector of the Speaker/Microphone on the trans- ceiver body; secure the connector pin using the screws supplied with the Speaker/Microphone.

Hold the speaker grille up next to your ear while receiving. To transmit, press the PTT switch on

the Speaker/Microphone, just as you would on the main transceiver’s body, and speak into the microphone on a normal voice level.

Note: Save the original plastic cap and its mount- ing screws. They should be reinstalled when not using the Speaker/Microphone.

4