from position 1 to 2 will have only an effect in the headphones,
facilitating practice of a mix point or scratch point.
@2REHEARSAL MUTE/FREEZE INDICATOR LED
When the Rehearsal Mute/Freeze feature is active this
LED will illuminate.
@3INPUT FADER
An input fader is used to adjust the input level on a given
PGM. The input fader on this unit is a PCV fader and utilizes
Vestax ReX fader exchange technology. This fader is user
replaceable. For comprehensive information on how to replace
this ReX PCV Fader please see the "How To Change The
Fader Unit" section of this manual.
@4LEVEL METER SELECT SWITCH
This switch is used to select which signal level is displayed.
When set to PGM, both sides of this LED section will
display the current PGM level, with the left side showing
PGM 1 and the right side showing PGM 2. When set to
MASTER, the two LED indicators will show the L&R
channels of the master signal being outputted.
@5LED LEVEL METER
As above.
@6CF REVERSE INDICATOR.
This LED is illuminated when the CF has been reversed as
described in !1.
@7CROSS FADER (CF)
Assuming that the CF reverse is off, Rehearsal Mute is off, and
that the input levels of both PGM 1 and PGM 2 are properly
set, then when the CF is at position 1 the signals from PGM 1
can be heard and when the CF is at position 2 the signals from
PGM 2 can be heard.
@8MONITER LEVEL
This fader is used to adjust the volume level heard in the
headphone section.
@9MONITER CF
This fader is used to adjust which PGM is heard in the
headphone section.
#0INPUT FADER CURVE SWITCHES
These switches may be used to adjust the fader curve setting
for either input fader. There are three setting from which to
make a selection (A, B & C) each with a different gradient.
#1
CROSS FADER CURVE (CF) CURVE ADJUST CONTROL
This knob is used to adjust the slope of the CF curve. Any
curve located between the two extreme positions, gentle &
steep, is possible and up to the preferred curve type of any user.
Rotating this knob in a clockwise manner will produce a steep
curve more suited to scratching cutting. An anticlockwise
rotation will have the opposite effect of producing a gentler
slope more suited to long mixing.
#2HEAD PHONE JACK
Used to connect suitable headphones to this unit. We
recommend that users pay particular attention to the
impedance level of their headphones. An impedance level of
between 8ohm and 600ohm is best for this unit.
FRONT PANEL