English
–In SPLIT mode, the split time function enables users to stop the counter to read an intermediate time while continuing timing. When the counter is restarted, the chronograph makes up the elapsed time.
–In ADD mode, you can start and stop the counter. Each time you stop the counter the time is stopped and does not take into consideration the elapsed time.
–To reset the counter to zero, push the crown and hold it down for more than 2 seconds.
–The maximum operational duration is 47 hours, 59 minutes and 59.99 seconds.
–While the chronograph is operating, it is possible to select and use the other timepiece functions at the same time (except for the alternative chronograph mode).
–In order to change the mode (ADD/SPLIT) you have to stop and reset the running chronograph to zero.
–If either of the modes ADD or SPLIT is selected, the display shows the following information:
Timed period < 1 minute:
– SP or Ad mode – seconds – hundredths.
Timed period > 1 min and < 1 hour:
– Minutes – seconds – hundredths alternately with modes SP + or Ad.
16
English
Timed period > 1 hour and < 48 hours:
–Hours – minutes – seconds alternately with modes SP + hundredths or Ad + hundredths.
9. USING THE ALARM
Test of alarm
Push the crown and hold down for more than 2 seconds after first selecting the Alarm (AL) function (Fig. 9). The alarm will start to sound at this point.
–Select the Alarm (AL) function (Fig. 9).
–Pull out the crown. The numerals start to flash.
–Display the desired time by turning the crown clockwise or
–Push the crown back down. The alarm is then set, with AL showing on the display ().
–To activate / deactivate the alarm, push the crown after first selecting the Alarm (AL) function (Fig. 9).
–AL display = alarm set (armed) ().
–OF display = alarm not set (disarmed) ().
–Push the crown down to stop the alarm.
Note: Since the timepiece can operate in either 12 hour
17
