Vidikron VP-4200, VP-6000a, VP-5000 4Operation, Turning on the Power, Changing the OSD Language

4Operation

1.Turn on your source components.

2.Attach the two included ferrite cores to each end of the AC power cable as shown in Figure 4-1.Doing so will reduce radio frequency interference (RFI) emissions to a level that conforms to FCC regulations. Use the supplied cable ties to secure the cores in place.

4.1

Turning on the Power

Ferrite core

Cable tie

To power outlet

To AC IN

AC power cord

As close as possible

Figure 4-1. Attaching the Ferrite Cores to the Power Cable

3.Plug the female end of the power cord into

the AC receptacle on the rear of the PlasmaView (AC 100V ~ 240V). Connect the other end to your AC power source.

4.Set the main power switch at the rear of the

PlasmaView (see Figure 2-4)to the “on” position. Its power indicator lights red.

5.Press the POWER button on the underside of the PlasmaView (see Figure 2-1)or the remote control (see Figure 2-5). The power indicator lights solid green.

6.After a brief warm-up period (approximately 10 seconds), the PlasmaView will display an image.

The PlasmaView OSD language is initially set to English, but can also display the menus in German (Deutsch), French (Français), Spanish (Español) or Italian (Italiano). To change the OSD language:

1.Press MENU.

2.Press repeatedly to select Option from the Main Menu.

3.Press SET to select Language.

4.Press the right- or left-arrow button ( or ) to highlight the desired language and press SET. The change takes effect immediately.

Vidikron PlasmaView Owner’s Operating Manual 27

4.2

Changing the OSD Language