Installation
Vidikron PlasmaView Owner’s Operating Manual 19
PRELIMINARY
3.4 Connections to the PlasmaView and VHD ControllerProceed as follows to connect the PlasmaView to the VHD Controller, your video sources,
external controller(s) – if present – and AC power.
When connecting your equipment:
• Turn off all equipment before making any connections.
• Use the correct signal cables for each source.
• Ensure that the cables are securely connected. Tighten the thumbscrews on connectors
that have them.
Connecting the PlasmaView
to the VHD Controller
Connect the VHD Controller to the PlasmaView as shown in Figure 3-3 and described in the
sections that follow.
Figure 3-3. Connecting the PlasmaView to the VHD Controller
Pb Pr Y
Video
3
IRRS-232 Control
S-Video 1
S-Video 2
HD1HD212
R/Pr G/Y B/Pb
R/Pr G/Y B/Pb H V
HDMI 1 HDMI 2HDMI Out
HV
TRIGGERS
RS-232 Out
CAUTION: TO REDUCE THE RISK OF ELECTRIC
SHOCK, DO NOT REMOVE COVER. NO USER-
SERVICEABLE PARTS INSIDE. REFER SERVICING
TO QUALIFIED SERVICE CENTER.
AVIS: RISQUE DE CHOC ELECTRIQUE-NE PAS OUVRIR
CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
!WARNING:
TO REDUCE THE RISK OF FIRE
OR ELECTRIC SHOCK, DO NOT EXPOSE
THIS APPLIANCE TO RAIN OR MOISTURE.
100-230VAC 50-60 Hz, 165 Watts Max
INPUTSSYSTEM CONTROL INTERFACEComponent Video
SDI
Option
Serial No
Video Processor / Controller
Model
Made In USA
SERIALPC INAUDIOSLOT1 SLOT3PR/CR/R PB/CB/BY/GAUDIORLCOMPONENT/RGB INSLOT2AUDIODVI-D IN