Vidikron PlasmaView Owner’s Operating Manual 27
PRELIMINARY
4.1 Turning on the Power
1. Turn on your source components.
2. Plug the female end
of the power cord
into the AC receptacle
on the rear of the
PlasmaView. Connect
the other end to your
AC power source.
3. Similarly connect the VHD Controller to a nearby AC outlet.
4. Press the main power switch at the front of the PlasmaView (see Figure 2-1). The
standby/on indicator lights green.
5. Set the main power switch at the rear of the VHD Controller (see Figure 2-4) to the “on”
position.
6. Press the ON button on the remote control to turn
on the VHD Controller and PlasmaView (or press
the power button on the front of the VHD
Controller). The power indicator on the VHD
Controller lights solid blue.
7. After a brief warm-up period (approximately 10
seconds), the PlasmaView will display an image.
4Operation
LIGHT
OFF ON