![](/images/new-backgrounds/1014863/148639x1.webp)
REFRIGERATOR INSTALLATION
Use two or more people to move and install refrigerator. Failure to follow this instruction can result in back or other injury. To avoid personal injury, wear gloves when performing any installation procedure and wear eye protection when cutting metal straps.
TIP OVER HAZARD
Refrigerator is top heavy and tips easily when not completely installed. Keep doors closed until refrigerator is completely installed and secured with lag bolts to rear wall.
Use two or more people to move and install refrigerator. Failure to do so can result in death or serious injury.
Most of the refrigerator’s weight is at the top. Extra care is needed when moving the refrigerator to prevent tipping. Do Not remove protective film until refrigerator is in operating position. All four leveling rollers must contact the floor to support and stabilize the full weight. Do not drop refrigerator.
Figure 1
1. Remove exterior shipping materials prior to moving refrigerator into home. Remove top and bottom strap (see Figure 1).
2.Remove top cap (see Figure 1).
3.Cut carton rear approximately 1/4” (.64 cm) to 1” (2.5 cm) from right corner (see Figure 2) with a utility knife extended 1/4” (.6 cm). Remove carton, exterior packaging, and lag
screw tape. Save cardboard shipping |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| Figure 3 |
| ||
material to protect floor surface when |
|
|
|
|
|
|
|
|
|
| ||
installing refrigerator. Do not remove nylon |
|
|
|
|
|
|
|
| ||||
|
|
|
|
|
|
|
| |||||
|
|
|
| |||||||||
|
|
|
|
|
|
| ||||||
cord from power cord. Remove |
|
|
|
|
|
|
| AND LAG SCREWS | ||||
board, lag screws, door trim insert, and |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| |
kickplate from rear of refrigerator (see |
|
|
|
|
|
|
|
|
|
|
|
|
Figure 3). |
|
|
|
|
|
|
|
| KICKPLATE |
|
| |
|
|
|
|
|
|
|
|
|
| |||
|
|
|
|
|
|
|
|
|
|
|
|
|
4.Remove shipping brackets from skid by removing 4 bolts (2 each side) with a 7/16”
socket head screwdriver (see Figure 4). •Tilting refrigerator is not required to remove shipping brackets.
Figure 2
BACK VIEW
Figure 4
5. Slip cart between | Figure 5 |
refrigerator and skid. |
|
Remove refrigerator |
|
from skid. Use excess |
|
packaging to protect |
|
decorative trim. Verify |
|
that leveling legs are |
|
up (0” adjustment) |
|
(see Figure 5). |
|
SKID |
6.To avoid floor damage,
use protective material (see Figure 6).
Figure 6
5