Viking F20050 EN manual Attaching the Handle, Attaching the Wood Frame to the Door Dfuw Model

FOR A 3-1/2” TOE KICK

(COVERS THE ENTIRE DOOR EXTRUSION)

(RIGHT HINGE)

7 13/16” (19.8 cm)

Attaching the Handle

Attach the handle of your choice by drilling mounting holes through panel. Countersink or counterbore holes from backside of panel for handle screw heads to be flush.

Attaching the Wood Frame to the Door - DFUW Model

1.If the door is attached to the unit, remove by unscrewing the top allen head set screw at the top hinge. Remove the door by angling the door off of the bottom hinge pin.

2.Install the supplied lock body into the wood panel. Secure the lock body by using the supplied 15mm lock retaining nut . Screw the retaining nut onto the lock body’s threaded section. Make sure the lock’s key slot is vertical, then tighten the nut wit h a 15mm deep well socket.

3.Peel back the d oor gasket to expose the screw holes and lock location hole.

4.Set the wood frame flush to the front of the door in the desired location. Clamp the wood frame to the door if necessary. Check to make sure the back of the lock in the wood frame lines up with the hole in the door.

5.Insert the wood screws through the back of the door into the pilot holes in the woo d frame and tighten.

6.Assemble the door lock’s phillips head screw, lock extension, and lock cam. Mount them to the back of the lock body. The cam should be oriented vertically. Tighten the phillips head screw to secure the lock assembly.

7.Reinstall the door gasket by pressing into the door channel. Make certain the corners are inserted fully. Insert the key into the lock and make sure lock operates properly.

8.Install the door to the unit. Use the supplied plastic washer as shown in the figure below.

9.Realigning the door may be necessary. Any final door adjustments can be made using a 1/8” allen head driver to adjust the door’s hinges. (See figure below)

10.Attach the door to the unit by reversing step number 1 above.

11.Insert the key into the lock and verify that the lock cam works properly with the catch bracket on the cabinet front.

Hinge Hardware Installation Details

CAUTION	CAUTION
Door can become	Door can become
disengaged if washers	disengaged if
are not installed.	washers are not
	installed.

		Wood
		Frame
	Door Hinge
				Shoulder bushing
				3/4” OD x 7/16”
				ID Washer
				3/4” OD x 1/4” ID
CAUTION				Washer
Door may not swing properly
			(3) Nylon hardware
if all nylon components are			components at
not installed as shown			bottom hinge

	(2) Nylon
	hardware
Cabinet
Hinge	components at
	top hinge

		Magnetic door	3/8” clearance
	5/8”x 7/32” ID washer
		gasket	holes for
	Shoulder		frame wood
	bushing		screws -
			10 holes
Door Hinge

		Rear of Door
	Wood Frame
Top Hinge Cover

Bottom Hinge Cover

			1/8” allen head screws for hinge
	Door hinge		adjustment
	adjustment	screws
				Bottom of door
Attached wood frame

12 13