Viking F20529 manual Clearance Dimensions Electrical Requirements

Clearance Dimensions

Electrical Requirements

Proximity to Side Cabinet Installation

•The cooktop may be installed directly to existing base cabinets.

•The cooktop CANNOT be installed directly adjacent to sidewalls, tall cabinets, tall appliances, or other side vertical surfaces above 36” (91.4 cm) high. There must be a minimum of 6” (15.2 cm) side clearance from the cooktop to such combustible surfaces above the 36” (91.4 cm) counter height.

•Within the 6” (15.2 cm) side clearance to combustible vertical surfaces above

36” (91.4 cm), the maximum wall cabinet depth must be 13” (33.0 cm) and wall cabinets within this 6” (15.2 cm) side clearance must be 18” (45.7 cm) above the 36” (91.4 cm) high countertop.

•Wall cabinet above the cooktop must be a minimum of 36” (91.4 cm) above the countertop for a full width of the cooktop.

Minimum Clearances from Adjacent Combustible Construction

•Above countertop 36” (91.4 cm) minimum

•Side 6” (15.2 cm)

•Rear 0” (0.0 cm)

•Within 6” side clearance. Wall cabinets no deeper than 13” (33.0 cm)

•Must be minimum 18” (45.7 cm) above countertop

•Wall cabinets directly above the product must be minimum 36” (91.4 cm) above the countertop

																		m		a	x		.
															3”							)
																			c
														1		3	.	0		m
														(3																		.
																														in
																												m
									.															6		”					)*
							i	n													3								cm
					m																					.	4
																									1
		8”							)												(9
						c
1			5	.7		m
(	4								(		6”
									1
									5		2		mi
										.		c		n
												m		)*	.
														*

				m		in	.
		”					)
	6					m
3				4	c
			.
		1
(9

Dimensions shown are for use with combustible surfaces unless otherwise stated.

*Note: 36” minimum unless using a hood.

**Note: Only applies to combustible surfaces.

	0
(		”		m
	.
0		0			in
			c .
				m
				)

		3
(			-
				1
7					/
	.
		9c				8
						”
				m
						)

WARNING

ELECTRICAL

GROUNDING

INSTRUCTIONS

This cooktop must be electrically grounded in accordance with local codes or, in the absence of codes, with the National Electrical Code, ANSI/NFPA 70- latest edition. FOR PERSONAL

SAFETY, THIS APPLIANCE MUST BE PROPERLY GROUNDED.

Electrical Requirements

Check your local codes regarding this unit. This cooktop is supplied with a 3-wire, A.C. 208V/120 volt or 120V/240 volt, 60 HZ electrical system. A white (neutral) is not needed for this unit. See next section for grounding instructions. It should be fused separately.

CAUTION

Be sure the electric power is off from the breaker box to the junction box until the cooktop is installed and ready to

operate. The junction box should be connected to a suitable ground.

Refer to the specifications chart for kilowatt rating and recommended amperage. House wiring and fusing must comply with local codes. If no local codes are applicable, wire in accordance with the National Electrical Code, ANSI/NFPA 70-latest edition.

WARNING

The electrical power to the unit must be shut off while line connections are being made. Failure to do so could result

in serious injury or death.

Electrical Connection

When making the wire connections, use the entire length of the conduit provided (3 feet). The conduit must not be cut. Connect the red and black leads from the unit conduit to the corresponding leads in the junction box. The bare ground wire in the conduit is connected to the unit frame. When connecting to a 3-conductor branch circuit, connect the bare ground connector lead of the unit to the branch circuit ground (bare wire or green in color).

WARNING

FIRE AND ELECTRICAL

SHOCK HAZARD

DO NOT use an extension cord with this appliance. Such use may result in fire, electrical

shock, or other personal injury.

8 9