![](/images/new-backgrounds/1063950/6395011x1.webp)
General Information
Final Preparation
READ AND FOLLOW ALL WARNING AND CAUTION INFORMATION WHEN INSTALLING THIS APPLIANCE.
•Keep appliance area clear and free from combustible materials, gasoline and other flammable vapors.
•Disconnect the electrical supply prior to servicing or cleaning.
•When removing the cooktop for service and/or cleaning, disconnect AC power supply.
•Electrical requirements are listed in the product specifications under the “Electrical Requirements” section.
•Some stainless steel parts may have a plastic protective wrap which must be peeled off.
•All stainless steel body parts should be wiped with hot, soapy water and with a liquid cleaner designed for this material.
If buildup occurs, DO NOT use steel wool, abrasive cloths, cleaners, or powders!
•If it is necessary to scrape stainless steel to remove encrusted materials, soak with hot, wet cloths to loosen the material, then use a wood or nylon scraper.
DO NOT use a metal knife, spatula, or any other metal tool to scrape stainless steel! Scratches are almost impossible to remove.
Installation
1 | 2 |
GroundGreen
Red
Black
Lower cooktop into cutout. | Connect the red and black leads from the unit conduit |
| to the corresponding leads in the junction box. |
Performance Checklist
A qualified installer should carry out the following checks:
■ Check top surface elements | 2. | Place an induction compatible piece of |
| cookware onto the left front | |
1. Starting with the left front element, turn |
| front indicator should be solid. |
the corresponding knob to the Hi | 3. | Remove cookware and repeat steps for |
| other elements. |
Service & Registration
Only authorized replacement parts may be used in performing service on the cooktop.
DO NOT repair or replace any part of the appliance unless specifically recommended in the manual. All other servicing should be referred to a qualified technician. Contact Viking Range Corporation,
VIKING RANGE CORPORATION
PREFERRED SERVICE
3
Countertop
Cooktop
Bracket
Screw brackets to burner box with sheet metal screw.
(Two bracket assemblies included)
4
Screw sheet metal screws into brackets
and tighten firmly against bottom of countertop.
Note: Be careful not to crack or damage
counter by overtightening.
1803 Hwy 82W
Greenwood, Mississippi 38930 USA
Cooktop – The serial number and model number for your appliance can be found by looking under the unit. Record the following information indicated below. You will need it if service is ever required.
Model number ____________________________________________________________________________________
Serial number _____________________________________________________________________________________
Date of purchase __________________________________________________________________________________
Date installed ______________________________________________________________________________________
Dealer’s name _____________________________________________________________________________________
Address ___________________________________________________________________________________________
These installation instructions should remain with the unit for future reference.
10 | 11 |