Installation (VWH 10” H./12”H. Wall Hoods w/Standard Ventilator)
1 | 2 |
Check damper for unrestricted movement, adjust if | Attach transition to damper. Seal with aluminum tape. |
necessary. |
|
3 | W A R N I N G |
| To reduce the risk of fire, electric shock, or injury |
| to persons, observe the following: |
• Use this unit only in the manner intended by the manufacturer. If you have any questions, contact the manufacturer.
• Before servicing or cleaning unit, switch power off at service panel and lock service panel to prevent power from being switched on accidentally. When the service disconnecting means cannot be locked, securely fasten a prominent warning device, such as a tag, to the service panel.
Flip hood over and remove electrical box cover.
6
5/16” nut driver
CAUTION: Secure vent hood to wall using screws provided. Use additional mounting screws and wall anchors, if necessary.
7 | BARE OR GREEN |
GREEN
BLACK
WHITE
WHITE | BLACK |
|
Connect black to black, white to white, and the
green/bare wire under the green screw.
NOTE: Housing wiring must be properly installed for
wiring to be correct when wiring unit.
5/16” nut driver
CAUTION: If not using a duct cover, using screws provided, make sure top mounting screws are secured into soffit or cabinet framing. Use additional mounting screws, if necessary.
8
1 | 1 | |
2 | ||
|
Replace electrical box cover. Make connection to
breaker box.
4
1 |
5
1
2 |
9
3
2
10
1
3
2
Insert 6” of electrical wiring through the top of vent hood | Slide duct over transition and tape around joint. |
and secure using wiring restrain. Refer to local codes. |
|
Slide filter front over front lip. Push filter rear up, then
slide back over rear lip.
Slide filter front over front lip. Push filter rear up, then
slide back over rear lip.
28 | 29 |