Viking Refrigerator Drawer manual Operating Instructions, Interior Light, Led Light Replacement

OPERATING INSTRUCTIONS

General Tips and Suggestions

•After making a temperature adjustment, allow at least 24 hours for your unit to reach a new temperature setting. •The motor will start and stop often. It must do this to maintain the temperature setting.

•Unplug the unit before working on anything with the electrical system.

•Exercise caution when sweeping, vacuuming, or mopping near the front of the unit. •Avoid leaning on the drawer fronts. You may bend the drawer slides or tip the unit.

Setting the Controls

The temperature of our drawer unit ranges from 32oF to 47oF (0oC to 8oC). The temperature can be adjusted using the control panel located on the inside of the top drawer. To change the temperature setting, press the warmer or cooler pads until the display shows the desired temperature. After a few seconds the display will return to the actual temperatures. To change from Farenheit to Celsius, simply press the warmer and colder keypads simultaneously. The display will change within a few seconds.

The on/off key pad stops and starts the cooling of the unit. This can be used when your drawer refrigerator will not be used for extended periods of time. The LED light will continue to operate when the drawers are opened as long as the unit is connected to a power source.

At time of initial start up the control panel display will show “OR” for “Out of Range” until the unit reaches the desired temperature.

34oF 01oC

OR

INTERIOR LIGHT

WARNING

ELECTRICAL SHOCK HAZARD Failure to disconnect the power cord when changing the light bulb may result in electrical shock.

CAUTION

Never pour liquids directly onto light assembly

LED LIGHT REPLACEMENT

1.Unplug unit.

2.Remove drawers. (This is not required to remove the light, but will provide better access). See Figures 1 through 3 in Full Overlay Panel Installation on page 6.

3.Remove old lights. Use 2 small, thin bladed screwdrivers or putty knives to press in the locking tabs on the lens housing. (Figures 4 and 5). With the locking tabs depressed, pull downward (Figure 6), the light housing will pop free. Disconnect the wire lead by pulling straight out from the connector. Connect wire lead to new light and re- install into metal housing. The light will only fit in the housing with the locator tabs pointing to the front of the unit.

4.Re-install drawers.

5.Plug in unit.

Figure 4

Figure 5 Figure 6

9