Viking Refrigerator Drawer Electrical Connection, Final Preparation, Electrical Shock Hazard

ELECTRICAL CONNECTION

WARNING

ELECTRICAL SHOCK HAZARD

Failure to follow these instructions could result in fire or electrical shock.

Electrical Requirements

Power Supply

Grounding type wall

A 115 volt, 60 Hz, AC only 15 amp fused electrical supply is required. (A time

with 3-prong

receptacle

delay fuse or circuit breaker is recommended.) It is recommended that a separate circuit, serving only this appliance, be provided.

•ELECTRICAL GROUND IS REQUIRED ON THIS APPLIANCE.

•DO NOT UNDER ANY CIRCUMSTANCES REMOVE THE POWER SUPPLY CORD GROUND PLUG.

•DO NOT USE AN EXTENSION CORD

grounding plug

Recommended Grounding Methods

For your personal safety, this unit must be grounded. This appliance is equipped

with a 7’ (2.1 m) power supply cord having a 3-prong grounding plug. To minimize possible shock hazard, the cord must be plugged into a mating 3-prong grounding type wall receptacle grounded in accordance with the National Electrical Code and local codes and ordinances. If the circuit does not have a grounding type receptacle, it is the responsibility and obligation of the customer to exchange the existing receptacle in accordance with the National Electrical Code and applicable local codes and ordinances. The third ground plug SHOULD NOT, under any circumstances, be cut or removed. All UL listed refrigerated drawers are equipped with this type of plug.

FINAL PREPARATION

1.Some stainless steel parts may have a plastic protective wrap which must be peeled off. The interior of the unit should be washed thoroughly with hot, soapy water, rinsed and wiped dry to remove film residue and any installation dust or debris before being used. Solutions stronger than soap and water are rarely needed.

2.All stainless steel parts should be wiped with hot soapy water. If buildup occurs, do not use steel wool, abrasive cloths, cleaners, or powders. If it is necessary to scrape stainless steel to remove encrusted materials, soak with hot, wet cloths to loosen the material, then use a wood or nylon scraper. Do not use a metal knife, spatula, or any other metal tool to scrape stainless steel; scratches are almost impossible to remove.

WIRING DIAGRAM

UNDERCOUNTER 24” W. REFRIGERATED DRAWER

WARNING: ELECTRICAL

GROUNDING

INSTRUCTIONS

This appliance is equipped with a three prong grounding plug for your protection against shock hazard and should be plugged directly into a properly grounded three prong receptacle. Do not cut or remove the grounding prong from this plug.

8