BUTTONS OF THE REMOTE CONTROL
17. MUTE
Pressing this button once mutes the headphone (8) and the preamplifier outputs (14). Pressing it again returns to the original volume.
18. VOL
These buttons change the amplifier’s volume | 17 |
INSTALLATION
Set up the cable links in a sequence as follows. Connect the power cable between device and power supply only after all other connections have been made.
DURING INSTALLATION PLEASE
OBSERVE THE FOLLOWING ADVICE:
setting for headphone and the preamplifier outputs (14).
18
Protective caps
Prior to the first installation the pro- tective plastic caps must be removed from all the connections used at the rear of the unit.
RCA connections
1 2
OUTPUTOU
Cable connections
Make sure that all plugs fit tightly. Inadequate con- nections can cause noise interference, failures and malfunctions.
Mechanically identical RCA plugs are available for input and output connections. Make sure that you do not get these connections confused during installation!
Make sure that you do not mix up the analogue connectors for right and left. The RCA plugs for these are mostly colour coded as follows: red for the right channel, black or white for the left channel.
Contacting the middle pin of the RCA plugs with the outer ring of the RCA chassis jack may lead to damages to the main amplifier if it is switched on! To avoid this hazard, connect or disconnect only in
- wrong -- correct -
To make the most of the components’ sound poten- tial, only high quality loudspeakers and connecting cables, for example Vincent cables, should be used. Your local stockist will be glad to advise you about this.
30 Vincent | Vincent 31 |
