FULL REFRIGERATOR CONFIGURATION

To convert appliance into “All Refrigerator” configuration, please follow below:

1.Turn the control knob to the “OFF” position.

2.Close the main valve on the CO2 cylinder.

3.Close the secondary shut-off valve on the regulator pipe.

4.Close the connection between the beer keg and the keg coupler.

5.Drain any remaining beer from the lines.

6.Disconnect the beer line and CO2 air line from the keg coupler.

7.Remove the beer keg and bottom metal plate.

8.Remove the keg coupler.

9.Disconnect the air line from the CO2 cylinder.

10.Remove the CO2 air line from cabinet plug

11.Replace the air line rear cabinet plug.

12.Remove the beer tower. Also pull the beer line thru the top of the cabinet.

13.Replace the top cabinet plug.

14.Remove the guard rail and cover the guard rail installation holes by the provided plugs.

15.Install the two wire shelves to the designated positions.

16.Adjust temperature as desired.

OPERATING YOUR BEER DISPENSER

Setting The Temperature

To start, turn the temperature control knob to the maximum setting (6). Allow the unit to run for a minimum of 3 hours at the maximum setting to cool down

unit. Temperature range of the thermostat goes from 36°F to 45°F (2.2ºC to 7.2ºC). Thereafter, adjust the thermostat to desired temperature.

Optimum temperature for serving draught beer is 34°F – 38°F (1.1ºC – 3.3ºC) and that is a key factor to consider in storing and dispensing draught beer. Note: Suggested temperature control knob position is between “4” and “5”.

To turn off the beer dispenser, turn the control knob to the “OFF” position.

NOTE: Keep an accurate thermometer handy and adjust temperature control setting as necessary or according to your needs.

Automatic Defrosting

There is no need to defrost the beer dispenser. Defrost water collects and passes through the drain outlet in the rear wall into a tray located above the compressor, where it evaporates.

NOTE:

ƒIF THE UNIT IS UNPLUGGED, LOST POWER, OR TURNED OFF, YOU MUST WAIT 3 TO 5 MINUTES BEFORE RESTARTING THE UNIT. IF YOU ATTEMPT TO RESTART BEFORE THIS TIME DELAY, THE BEER DISPENSER WILL NOT START.

ƒTURNING THE TEMPERATURE CONTROL TO “OFF” POSITION STOPS THE COOLING CYCLE BUT DOES NOT SHUT OFF THE POWER TO THE UNIT.

1 7 6 2 1 S o u t h S u s a n a R o a d , R a n c h o D o m i n g u e z , C a l i f o r n i a 9 0 2 2 1

11

i n f o @ v i n o t e m p . c o m