previously removed from).

7.Carefully slide the fridge door back on to the top hinge, making sure it’s the right way up. Screw the bottom hinge into place on the new side.

8.Check that door is aligned horizontally and vertically and that the seals are closed on all sides before finally tightening the bottom hinge. Re-adjust the leveling feet as needed.

9.If cooler has been on its side or tilted, always wait several hours before reconnecting to power source to allow the refrigerants to settle.

Installing the Castors

zRemove the 4 castors from one of the boxes inside the unit. Install the two castors with metal bracket at the front designated positions of the cabinet base and the additional two castors at the rear-designated positions (Four screw holes are pre- supplied).

zIn order to release or lock the brake, follow the below guide.

Stepd own to Brake

Step on to Release Brake

Kegerator Assembly

•Place the gasket over the hole opening on the worktop.

•Pass both the wing nut and the beer tube through the hole on the worktop until the beer tap is resting on top of the cabinet.

•Revolve the beer tap clockwise and secure it.

•Spanner faucet wrench provided for either removing or tightening connection.

•Attach the black plastic lever (pull handle) provided on the top of the faucet tightening it by hand clockwise until the end, holding in the silver snug underneath so it does not move. (See Figure 1)

1 7 6 2 1 S o u t h S u s a n a R o a d , R a n c h o D o m i n g u e z , C a l i f o r n i a 9 0 2 2 1

7

i n f o @ v i n o t e m p . c o m