PARALLEL SYNCED GAIN CONNECTIONS/SETTINGS
1.Input/Output Signal - Connect these RCA jacks as described in the Front Panel Connections/Controls section of this guide.
2.Remote Sub Level Control - Connect the Remote Sub Level control to the 1100.5 only. The 1100.5 control panel subwoofer adjustments are used first to set the overall gain for all synced amplifiers, then the Remote Sub Level control can adjust the gain of all synced amplifiers by adjusting its control knob.
3.Signal Connection - Connect an RCA cable between the SYNC OUT RCA jack of the 1100.5 and the SLAVE IN RCA jack of the slaved d600.1 as shown in Figure 5.
4.Slave/Master Switch - Set the slave/master switch of the d600.1 to the slave position. This will put the I/O RCA jack in the SLAVE IN mode so it will accept the audio signal from the 1100.5’s sync out RCA jack.
5.Subwoofer Speaker Connection - In this amplifier combination each amplifier must drive its own separate subwoofer(s). Connect the speaker terminals of each amplifier to any combination of one or more subwoofers that results in nominal impedance between 1 and 4 ohms. Make sure that each amplifier sees the same speaker impedance.
© 2002 Directed Electronics, Inc | 15 |
