FRONT PANEL CONNECTIONS/STATUS LED
1.RCA Input Jacks - Accepts line level outputs from head units or signal processors between 150mV and eight volts.
2.RCA Sub Input Jacks - Accepts line level outputs from head units or signal processors between 150mV and eight volts for the subwoofer section of the amplifier.
3.RCA Output Jacks - These pass through RCA jacks can be used to send a signal to a second amplifier. It is the summed stereo output of the one through four channel inputs of the amplifier.
4.RCA Sync Out Jack - This RCA jack sends a synced, or
5.RCA Bridge Output Jack - This output sends an
6.Status LEDs - The Power LED will light GREEN to indicate the amplifier is on and operating normally. The GREEN LED will turn off and the Protection LED will light RED when the amplifier has shut itself down due to speaker short circuit, DC offset or overheating.
7.Remote Sub Level Control - Controls the subwoofer amplifier gain controls from a remote location for ease of adjustment during listening.
Warning: DO NOT connect a level control knob from other manufacturers to the Remote Sub Level Control of any Viper amplifier. Even though the connectors fit properly, the control knob and connector pin posi- tions may be different and the amplifier will be damaged.
FIGURE 1—AMPLIFIER CONNECTIONS 1100.5 FRONT
1 | 2 | 3 | 4 | 5 | 6 | 7 | |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
8 | © 2002 Directed Electronics, Inc |
|
