Viper 1100.5 manual Specifications, Viper model, Ch 1-4 Ch, Watts watts 125 250x2

SPECIFICATIONS

Viper model 1100.5

RMS continuous power per channel, Channels 1-4 driven into 4 ohms from 20 to 20,000 Hz, with less than 0.08% total Harmonic Distortion @ 14.4 VDC. Channel 5 driven into 4 ohms from 20-250 Hz, with less than 0.4% THD @ 14.4 VDC.

RMS continuous power per channel, Channels 1-4 driven into 2 ohms from 20 to 20,000 Hz, with less than 0.1% Total Harmonic Distortion @ 14.4 VDC. Channel 5 driven into 2 ohms from 20-250 Hz, with less than 0.6% THD @ 14.4 VDC.

RMS continuous power, 3-channel operation, channels 1-4 bridged into 4 ohms from 20 to 20,000 Hz, with less than 0.1% Total Harmonic Distortion @ 14.4 VDC. Channel 5 driven into 1 ohms from 20-250 Hz, with less than 0.6% THD @ 14.4 VDC.

Dynamic power rating (IHF-202 Standard) at minimum load

Signal-to-Noise Ratio

Frequency Response

Damping Factor @ 4 ohm

Crossover (Ch 1-4)

Subwoofer Crossover

Bass Equalization

Input Impedance

Input Sensitivity

Output Impedance (ch 1-4)

(ch 5)

Supply Voltage Fusing and Power

Minimum Cable Requirements (AWG) (Per amp, trunk mounted)

Ch 1-4 Ch 5

75275

watts watts

125400

watts watts

250x2 600

watts watts

1300 watts

Greater than 95 dB (Ch 1-4), 80dB (sub)

20-20,000 Hz ± 0.5 dB (Ch 1-4)

Greater than 100 (Ch 1-4), 50 (sub)

Switchable high or low pass 12 dB/octave, continuously variable 50 to 500 Hz

Low pass 24 dB/octave, variable 30 to 250Hz

Variable, 0 to 12 dB, centered at 40Hz

20K ohms

Variable from 150 mV to 8 volt

2 to 8 ohms, stereo

4 to 8 ohms, bridged

1 to 4 ohms

10 to 16 VDC

120A

#4

20 © 2002 Directed Electronics, Inc