TROUBLE CONDITIONS (Continued)

*The beeping that accompanies a low battery display (items 4 and 5) can be stopped by entering an OFF sequence (code + OFF)

**Not all systems use wireless transmitters.

3.COMM. FAILURE (or F C) Indicates that a failure has occurred in the telephone communication portion of your system.

CALL FOR SERVICE IMMEDIATELY.

4.

SYSTEM LO BAT

Indicates that a low system battery condition exists,

 

(or BAT with no zone No.)

accompanied by a once-per-minute "beeping"* at

 

 

the Keypad. CALL FOR SERVICE IMMEDIATELY.

5.

LO BAT + zone descriptor

Indicates that a low battery condition exists in the

 

(or BAT with zone No.)

wireless transmitter** displayed, and accompanied

 

 

by a once-per-minute "beeping"* at the Keypad.

 

 

CALL FOR SERVICE IMMEDIATELY.

6.

MODEM COMM

Indicates that the control is on-line with the central

 

(or C C)

station's remote computer. The control will not

 

 

operate while on-line. Wait a few minutes. The

 

 

display should disappear.

7.POWER indicator (if present) is off. AC LOSS is displayed (or NO AC)

The system is operating on battery power only.

If only some lights are out on the premises, check circuit breakers and fuses and reset or replace as necessary. CALL FOR SERVICE IMMEDIATELY if AC power cannot be restored to the system.

8.

Busy-Standby (or dI)

If this remains displayed for more than 1 minute,

 

 

system is disabled. CALL FOR SERVICE AT ONCE.

9.

OPEN CIRCUIT (or OC)

The keypad is not receiving signals from the control.

10.Long Rng Trbl (or bF) If programmed, back-up Long Range Radio communication has failed. CALL FOR SERVICE AT ONCE.

–32 –