Vita Spa L100 owner manual To switch to the ECONOMY mode

programmed hours. (See “Setting Filtration Hours”). Note that, if at the end of filtration cycle the water is not at the chosen temperature, the pump and heater will not continue to run until that temperature is reached. This mode is used for energy conservation, the same way you would control your heat or air conditioning in your house. The clock icon will be displayed when in ECONOMY mode.

To switch to the ECONOMY mode:

1.Press and hold the “PROG” button for

5seconds to enter the programming mode. “AH” will flash on the display.

2.Press “ UP” or “DOWN” button to change between ECONOMY (ECO) and AUTO HEAT (AH). Observe the clock icon when in ECONOMY mode.

3.Wait 30 seconds or press “Light” button to exit the programming mode.

C. SETTING CURRENT TIME

1.Press and hold the “PROG” button for 5 seconds to enter the programming mode. “AH” will flash on the display. If you are already in the programming mode, go to step 2 directly.

2.Press “PROG” one more time to show the Hour.Observe the flashing clock icon and PM indicator. No indicator means AM.

3.Press “UP” or “DOWN” to select the current hour.

4.Press “PROG” one more time to show the minutes.

5.Press “UP” or “DOWN” to select the current minute.

6.Wait 30 seconds or press the “Light” button to exit the programming mode.

D. SETTING FILTRATION CYCLES

Filtration cycles have been preset at the factory from 8 AM to 10 AM and from 4PM to 6 PM. They can be changed as follows.

1.Press and hold the “PROG” button for

5seconds to enter the programming mode. “AH” will flash on the display. If you are already in the programming mode, go to the step 2 directly.

2.Press “PROG” three times to show the filter cycle schedule. Notice the flashing filter icon.

3.Press “UP” and “DOWN” to change the hour.

4.Press “JET” button to change the filter from “-” (Off) to “F” (ON) or vice versa.

5.Wait 30 seconds or press the “LIght” button to exit the programming mode.

CIRCULATION PUMP (OPTION)

E. SETTING CIRCULATION PUMP

You are also given the choice between 12 forced hours of circulation or 24 forced hours, regardless of water temperature.

1.Press “PROG” until “AH” flashes

2.Press “PROG” 4 times “C=12” appears.

3.Press “UP” or “DOWN” buttons to change.

4.Press “LIGHT” button to clear or wait 30 seconds.

F.SKIM – AWAY (ONLY AVAILABLE WITH OPTIONAL CIRCULATION PUMP)

Skim–Away is an automatic skimming action which takes place each day from 8am until 8:30am each morning and from 4pm until 4:30pm each afternoon. The primary and secondary pumps will activate in low speed mode. This will pull all surface oils and debris into the filter well cavity.

This setting permits the skim-away

PAGE 14