23
Remote Control Operation
1. Make sure that the component is turned on.
2. Press and hold the SETUPbutton on the Remote Control until the LED flashes twice.
3. Press992,then press the component button on the Remote Control twice.
Checking the Component Codes
If you have set up the Remote Control using the Searching for Component Code procedure, you may need to
find out which four-digit code is operating your equipment.
Tofind out which code is operating your TV :
1. Press theTV button once.
2. Press and hold the SETUPbutton until the LED blinks twice, then release the SETUP button.
3. Enter990.Afterthis number sequence has been entered the LED will flash twice.
4.To view the code for the first digit, press 1 once. Wait 3 seconds, count the LED blinks (i.e., 3 blinks =3) and
write down the number.
5. Repeat step # 4 three more times for the remaining digits. Use 2 for the second digit. Use 3 for the third digit,
and 4 for the fourth digit.
6.To check the codes for your other components, repeat steps 1 through 5, but substitute the appropriate key (i.e.,
AUX, CBL, VCR, SAT,CD, AMP,or DVD) for the component you are checking. As before, write down each four-
digit code.
Changing VolumeLock
The Remote Control is set to control the volume through yourTV while in cable (CBL), DVD, satellite (SAT) and
VCR component modes. Use the volume lock if you want to control the volume for all components through a
specific component.

Example:

Youwant to control volume for all components through your tuner.
1. Press and hold the SETUPbutton until the LED flashes twice.
2. Press993.Afterthis number sequence has been entered the LED will flash twice.
3. Press the COMPbutton once that you want to control the volume (TNR). The LED flashes twice. Volume will
now be controlled through the tuner for all components.
Teachingthe Remote Control New Functions
The remote control can learn up to 40 additional functions from the component's original remote control.

Note: If a code digit is "0", the LED will not blink.

Example:

YourDVD player remote control has a scan function that you may use frequently. There is not a scan button on the
remote control. you can assign a button and use the DVD remote to teach the remote control the scan function.
1. Press and hold the SETUPbutton on the Remote Control until the LED flashes twice.
2. Press975.Afterthis number sequence has been entered the LED will flash twice.
3. Press the COMPbutton that you want to teach (DVD) once.
4. Press the button to which you want to assign the new function.The LED flashes quickly while it is waiting to
receive the signal from the teaching remote.
5. Hold the teaching remote control approximately 1-inch (25mm) from the Remote Control making sure that the
infrared ports are lined up, on the teaching remote press the button that you want the Remote Control to learn.
The LED flashes twice.
6. Press the SETUPbutton to exit the learning mode.