WARNING:Thecooling fan in the REAR PROJECTION TV continues to run for about 150 seconds before the REAR
PROJECTIONTV enters the standby mode. During normal Operation, when putting the REAR PROJECTION TV
intostandby mode always use the POWER button on the REAR PROJECTION TV or on the remote control. Ensure
thecooling fan has stopped before disconnecting the power cord. DURING NORMAL OPERATION, NEVER TURN
THETELEVISION OFF BY DISCONNECTING THE POWER CORD. FAILURE TOOBSERVE THIS COULD RESULT IN
PREMATURELAMP FAILURE.
WARNING:
EYEDAMAGE MAY RESULTFROM DIRECTLY VIEWING THE LIGHT PRODUCED BY THE LAMP USED
INTHIS APPARATUS.ALWAYSTURN OFF LAMP BEFORE OPENING THIS COVER.
LAMPREPLACEMENT WARNING :
REFERTO THE INSTRUCTION MANUALBEFORE REMOVING THE SCREW, DISCONNECT POWER
CORD.HOT SURFACE INSIDE.ALLOW 45 MINUTES TO COOL BEFORE REPLACING THE LAMP.
REPLACEWITH SAME LAMP UNIT ONLY.
THISCOVER IS PROVIDED WITH AN INTERLOCK TOREDUCE THE RISK OF EXCESSIVE
ULTRAVIOLETRADIATION.DO NOT DEFEATITS PURPOSEOR ATTEMPTTO SERVICE WITHOUT
REMOVINGCOVER COMPLETELY.
MEDIUMPRESSURE LAMP : RISK OF EXPLOSION. POTENTIAL HAZARD OF GLASS PARTICLESIF
LAMPHAS RUPTURED. HANDLE WITH CARE.
iii
Potentialhazard of glass particles if lamp ruptures.
Incase of lamp rupture, contact your nearest
AuthorizedProjector Dealer or Service Center for a
replacement.See "Replacing the Lamp" on Page 31
ReplacementLamp Part Numbers:
UHP(120W Lamp) RP51
USERSERVICE SCREW.
VISPOUR ENTRETIEN PAR
L'UTILISATEUR.
CautionConcerning Lamp Replacement
See"Replacing the Lamp" on Page 31,32
WARNING
EYEDAMAGEMAYRESULTFROMDIRECTLYVIEWINGTHELIGHTPRODUCEDBY THE LAMP
USEDINTHISAPPARATUS.ALWAYSTURNOFFLAMPBEFOREOPENINGTHISCOVER.
WARNING
EYEDAMAGEMAYRESULTFROMDIRECTLYVIEWINGTHELIGHTPRODUCEDBY THE LAMP
USEDINTHISAPPARATUS.ALWAYSTURNOFFLAMPBEFOREOPENINGTHISCOVER.
LAMPREPLACEMENTWARNING
REFERTOTHEINSTRUCTIONMANUALBEFOREREMOVINGTHESCREW,DISCONNECT POWER CORD. HOT
SURFACEINSIDE.ALLOW45MINUTESTOCOOLBEFOREREPLACINGTHELAMP.REPLACE WITH SAME LAMP
UNITONLY.THISCOVERISPROVIDEDWITHANINTERLOCKTOREDUCE THE RISK OF EXCESSIVE ULTRAVIOLET
RADIATION.DONOTDEFEATITSPURPOSEORATTEMPTTOSERVICEWITHOUT REMOVING COVER COMPLETELY.
MEDIUMPRESSURELAMP:RISKOFEXPLOSION.POTENTIALHAZARDOF GLASS PARTICLES IF LAMP HAS
RUPTURED.HANDLEWITHCARE.
LAMPREPLACEMENTWARNING
REFERTOTHEINSTRUCTIONMANUALBEFOREREMOVINGTHESCREW,DISCONNECT POWER CORD. HOT
SURFACEINSIDE.ALLOW45MINUTESTOCOOLBEFOREREPLACINGTHELAMP.REPLACE WITH SAME LAMP
UNITONLY.THISCOVERISPROVIDEDWITHANINTERLOCKTOREDUCE THE RISK OFEXCESSIVEULTRAVIOLET
RADIATION.DONOTDEFEATITSPURPOSEORATTEMPTTOSERVICEWITHOUT REMOVING COVER COMPLETELY.
MEDIUMPRESSURELAMP:RISKOFEXPLOSION.POTENTIALHAZARDOF GLASS PARTICLES IF LAMP HAS
RUPTURED.HANDLEWITHCARE.