
VIVOTEK
Waterproof Connector
Sealing Nut (A)
Housing (B)
Seals (C)
Seal (D)
Screw Nut (E)
Hex Nut (F)
(A)
(B)
(D)
(E)
Assembling Steps
1.Disassemble the components of the waterproof connector into parts (A) ~ (F) as shown above.
2.Place the screw nut (E) on the Power and GPIO opening.
3.Feed the power cables through the waterproof connector (F
4.If you have external devices such as sensors and alarms, feed the cables through the waterproof connector (F
(F)
Refer to the pin definition to connect them to the general I/O terminal block. Note: The recommended cable gauge is 2.0 ~
2.8 mm.
5.Push the seal (D) into the housing (B).
6.Insert the seals (C) into unused holes on the seal (D) to avoid moisture.
7.Secure the sealing nut (A) tightly and hex nut (F) from the bottom of the camera.
10 - User's Manual