VIVOTEK
Connecting RJ45 Ethernet Cable
RJ45 Cable Dimension (unit: mm)
Recommended cable gauge: 24AWG (0.51 mm)
Assembling Steps
NOTE:
This equipment is only to be connected to PoE networks without routing to outside plant.
1Rubber Seal
Plug | 1. Drill a hole on the rubber seal plug and insert | |
an Ethernet cable through the opening. | ||
|
2
3
2. Strip part of the sheath from the Ethernet ca- ble.
o:white/orange stripe O: orange solid
g:white/green stripe B: blue solid
b:white/blue stripe G: green solid
br: white/brown stripe
BR: brown solid
4
o
O g
B b
G br
BR
1
2
3
4
5
6
7
8
3. You will need an RJ45 crimping tool to attach the Ethernet wires to a connector. When done, connect the cable to the camera’s Ethernet RJ45 socket.
4.Feed the Ethernet cable from the bottom of the camera and through the hole. Attach the rubber seal plug for wa- ter proofing.
Connecting DC Power Cable
1.Remove the rubber stopper from the camera base.
2.Add the supplied rubber washer to the cable as shown in the picture.
3.Feed the cable from the bottom of the camera and tighten the plastic base for waterproofing.
10 - User's Manual
