Vivotek FE8171V Internet connection with static IP, When using a PoE-enabledswitch, PoE Switch

VIVOTEK

Internet connection with static IP

Choose this connection type if you are required to use a static IP for the Network Camera. Please refer to LAN configuration on page 58 for details.

Internet connection via PPPoE (Point-to-Point over Ethernet)

Choose this connection type if you are connected to the Internet via a DSL Line. Please refer to PPPoE on page 49 for details.

Set up the Network Camera through Power over Ethernet (PoE)

When using a PoE-enabled switch

The Network Camera is PoE-compliant, allowing transmission of power and data via a single Ethernet cable. Follow the below illustration to connect the Network Camera to a PoE-enabled switch via an Ethernet cable.

NOTE:

1. The camera is only to be connected to PoE networks without routing to outside plants.

2. For PoE connection, use only UL listed I.T.E. with PoE output.

POWER	COLLISION						LINK
		1	2				RECEIVE
				3	4	5	PARTITION

Power + Data Transmission PoE Switch

When using a non-PoE switch

If your switch/router does not support PoE, use a PoE power injector (optional) to connect between the Network Camera and a non-PoE switch.

PoE Power Injector

(optional)

POWER	COLLISION	1					LINK
							RECEIVE
			2	3	4	5	PARTITION

Non-PoE Switch

14 - User's Manual