Vivotek IP7160 manual Vivotek

VIVOTEK

■ Auto

The Network Camera automatically adjusts the color temperature of the light in response to different light sources. The white balance setting defaults to Auto and works well in most situations.

■ Keep current value

Follow the steps below to manually set the white balance to compensate for the ambient lighting conditions.

1.Set the White balance to Auto and click Save.

2.Place a sheet of white paper in front of the lens, then allow the Network Camera to adjust the color temperature automatically.

3.Select Keep Current Value to confirm the setting while the white balance is being measured.

4.Click Save to enable the new setting.

Image Adjustment

■Brightness: Adjust the image brightness level, which ranges from -5 to +5. The default value is set to -5.

■Saturation: Adjust the image saturation level, which ranges from -5 to +5. The default value is set to 0.

■Contrast: Adjust the image contrast level, which ranges from -5 to +5. The default value is set to 0.

■Sharpness: Adjust the image sharpness level, which ranges from -5 to +5. The default value is set to 0.

Enable Edge Enhancement

Edge enhancement is an image processing filter that enhances the edge contrast of an image or video to

improve its sharpness. Enter a value from 1 to 128 to set the degree of enhancement desired.

Enable Noise Reduction

Noise reduction is the process of removing noise from a signal. Select the type of noise to remove and enter a value from 1 to 63 to set the degree of enhancement required.

You can click Preview to fine-tune the image, or click Restore to recall the original settings without incorporating the changes. When completed with the settings on this page, click Save to enable the setting and click Close to exit the page.

User's Manual - 55