Rear Panel (D-5.5E)

*The names of the functions on the D-5.5E are specified below as connection of the input channel on the D-5.5 is the same as the D-5.5E. Difference in functions and connection are explained.

Buss Link Connector

(BUSS LINK OUT)

This connector is used to link the D-5.5E Expander with the D-5.5. A six-foot connecting cord is included

with the D-5.5E.

Buss Link Connector

(BUSS LINK IN)

This connector is used to link the D-5.5E Expander with another D-5.5E Expan- der.

Earth Terminal

RCA Pre Accessory

Patch Points

(PRE IN/OUT)

RCA Post Accessory

Patch Points

(POST IN/OUT)

Direct Output

(DIRECT OUT)

RCA Tape Input (TAPE IN)

AC Power Cord (6 ft.)

Pushbutton Circuit Breaker (1A)

(PUSH RESET)

This breaker is designed to protect the D-5.5E in the event of internal or external fault. Wait about two mi- nutes after correcting the fault and push the button to reset the system and restore proper operation.

MIDI Thru Connectors

(MIDI THRU)

The MIDI signal from the MIDI input connector (MIDI IN) is split and sent un-

altered to the four MIDI Thru

connectors on the D-5.5, and to six more MIDI Thru con- nectors on the D-5.5E, if used. Each of the MIDI Thru jacks can be connected to a different synthesizer's MIDI input jack, allowing one MIDI keyboard or sequencer to control up to four other MIDI synths. (ten when using the D-5.5E and sixteen when

using the two D-5.5E's.)

Balanced XLR Microphone Input (MIC)

Phantom Power Switches (PHANTOM 9~20)

1/4" Phone Channel Input (INPUT)

— 14 —

Page 13
Image 13
Vizio instruction manual Rear Panel D-5.5E, Buss Link OUT