
Procedure for Changing Internal Switch Setting
NOTE:
The internal switches have been provided for added versatility when using the
AUX 1 / AUX 2 SEND PRE/POST EQ SELECTION SWITCH: Each input features an auxiliary send control
for use as either an additional effects send, or as an
and 2 control are a "split" pot with the detent position (12o'clock) being the off position. Typically, the control would be rotated clockwise ("post") when used as an effects send. This enables the effects level to
be automatically increased as the input channel level
increases. Obviously, since this signal is also derived "post" EQ, any changes made in the input channel's EQ
settings will be reflected in the effects signal. When the AUX 1 or 2 control is to be used as an
counter clockwise ("pre"). This allows the
monitor mix to operate independently of the input channel's fader. In other words, any change in the input
channel's fader will not affect the level of the monitor
mix. The Aux Send Pre/Post EQ Selection Switch is active only when the Aux 1 or 2 Control is used in the "pre" (counter clockwise) position. When the switch is set to the "pre" EQ position, the input channel's EQ controls will not affect the
NOTE:
The Aux 1 and 2 controls are unable to independently derive the pre or post EQ signal via the pre/post EQ selection switch, but always derive the same signal.
Also the selection switch provides the pre or post EQ
signal for the cue switch.
WARNING
The D-5.5 and D-5.5E contain voltage levels that may be
hazardous to human life. Always disconnect the power cord from wall outlet prior to removing either unit's
outer case.
1.Disconnect the power cord from the wall outlet.
2.Remove the four screws that secure the bottom panel to the main chassis, and carefully remove the panel (See Fig 1)
Fig l
INPUT
CHANNEL
PRE PRE PRE PCB
POST POST POST
BUSS LINK
CONNECTOR
Fig 2
3.Refer to block diagrams and Figure 2 for location and orientation of switches.
4.Set switches to desired positions.
5.Carefully replace the bottom panel and secure with four screws.
6.The Aux send pre/post EQ switch is factory preset at "POST" position
— 19 —