Turn the Receiver Module Off and On
1.To turn the receiver module Off, press and hold the Adjust button until two dashes are displayed (approximately 5 seconds), then release.
2.To turn the receiver On, press the Setup button two times. The receiver will return to the normal display mode within approximately 10 seconds.
Set or Restore the Sensor Address Code
The receiver and sensor modules are
1. Press and hold the | Smart Bypass button until all three |
|
Water Conservation indicators are illuminated and the | Setup |
icon begins blinking (approximately 15 seconds). See Figure 28.
2.Activate the sensor module at close range by pressing the test spindle until the Sensor Status indicator is illuminated, then release the test spindle. Refer to step 3 of “Initial System Test” on page 8 for additional information.
Figure 28
Note: If the Water Conservation level is set to Medium or Maximum, or the Dry Out feature is in
use, the sensor system will be activated. Press the Smart Bypass button to reset the receiver to the Monitor mode.
20