Initial Sensor System Test
Before installing the sensor module, test the sensor system to verify operation. Once this test has been completed satisfactorily, the sensor module can be installed. If a problem occurs during the test procedure, refer to “Troubleshooting” on page 22.
1. Apply power to the controller. Check controller operation to confirm that it is working properly.
2. When power is applied to the receiver, | |||
the “Min” |
| Water Conservation indicator will | |
| |||
illuminate. The | |||
alternating boxes and the | |||
display two flashing bars as shown in Figures 5 and 6. | |||
3. Holding the sensor module next to the receiver, press | |||
and hold the sensor test spindle down for at least 15 | |||
seconds to establish communication. See Figure 7. | |||
The | Sensor Status indicator will illuminate, | ||
the | Antenna icon will flash and the signal strength |
Figure 5 |
Figure 7
Figure 6 |
Figure 8 |
bars will appear. The |
the current air temperature. See Figure 8. |
4. When the Antenna icon stops flashing, release the |
test spindle. The receiver display will appear as |
shown in Figures 9 or 10. |
Figure 9 |
Figure 10 |
8