Troubleshooting
•No Display: (Screen is black)
-Verify that +12V power is correctly supplied to the A/V Control Module.
-Verify that the Monitor Cable is connected to the A/V Control Module.
-Verify that the + 12V circuit is on (i.e. ignition position).
-Verify that the Setup Operations steps were taken. (Page 4)
•No video: (screen displays blue screen)
-Make sure that all cables are connected properly.
-Make sure that the Camera Cable is connected to the A/V Control Module.
-Make sure the the Monitor power switch is toggled On.
Care and Maintenance
Your backup monitor system is a product of superior design and crafts- manship and should be treated with care. The suggestions below will help to fulfill warranty obligations and to provide many years
of enjoyment.
Cleaning the Monitor Screen and Housing:
•The components may be cleaned by gentle wiping with a soft,
CAUTION: Do not use liquids, abrasives, aerosol cleaners, or paper cleaning products because they will result in permanent damage to the finish of your components! The LCD screen is made of a specially coated glass and can be scratched or damaged by abrasive or
•Use and Storage:
-These units contain precision electronics that must be protected from dust, dirt, and moisture.
-Never spill liquids on any of the components. Liquids, humidity, and precipitation contain minerals that will corrode electronic circuits.
•Take care to avoid the following:
-Rough handling can break internal circuit boards. Do not drop, knock, or shake the components.
-Do not attempt to paint or refinish the components. Paint can clog moving parts and prevent proper operation.
-The components can be damaged by
6 | 7 |
