Troubleshooting
Problems | Solutions |
No sound output, RF/AF LED(s) are not glowing | • Make sure the microphone and receiver power |
| switches and receiver are set to the ON position. |
| • Check microphone charge to ensure there is |
| sufficient power. Charge mic if necessary |
• Check receiver’s AC power connection.
• Make sure antennas are firmly connected and extended to an optimal position.
• If necessary, reduce the distance between the microphones and receiver.
• Turn up the receiver’s VOLUME level controls.
• Check for proper connection between receiver and external amplifier/mixer.
• Talk into the microphone and observe the receiver’s RF/AF signal LED’s. If they glow, the problem is elsewhere in the sound system.
Received signal is noisy or contains extraneous | • Check microphone(s) charge and recharge if the |
sounds with the microphone(s) ON. | charge is low. |
| • Remove local sources of UHF interference, such as |
| lighting equipment. |
| • Adjust the squelch controls on the front of the UHF- |
| 5805 receiver. |
| • Signal may be too weak. If so, reposition antennas. |
| (If possible, move them closer to the transmitter). |
There is noise coming from the receiver with the | • Remove local sources of UHF interference, such |
microphones turned OFF. | as lighting equipment. |
| • Reposition the receiver or antennas. |
Momentary loss of sound as microphone(s) are | • Reposition the receiver, perform a “walkthrough”, |
moved throughout the operating range. | and observe the signal strengths. If audio dropouts |
| persist, mark these “dead spots” in the operating |
| area and avoid them during the performance. |
Erratic LED blinking on the main receiver modules | • Make sure the 14V power adapter is plugged |
| in to the main unit. Do not use the 9V adapters |
| with the main receiver unit. |
| • If the power adapter is the 14V and the main unit |
| lights are still blinking, contact VocoPro for a |
| replacement |
UHF-5805 Manual © VocoPro 2011
V 1.1
www.vocopro.com
15