1992 Volvo 240
WARNING!
●The jack's hook must engage the pin in the jack attachment (A). The car's weight must not rest on the jack's hook (B).
●Never crawl under a car supported by a jack.
●Use the jack intended for the car when replacing a wheel.
For any other job use stands to support the end of the car being worked on.
●Apply the parking brake, engage first or reverse gear (pos. P for cars equipped with automatic transmission).
●Block the wheels standing on the ground. Use rigid wooden blocks or large stones.
●The jack should stand on firm, level ground.
●The jack should be kept
●Do not rotate a raised rear wheel if the car is equipped with a limited slip differential. This will also rotate the opposite wheel (on the ground) and the car may slide off the jack.
pg. 98 Replacing wiper blades, Washing
Replacing wiper blades
Lift the wiper arm off the windshield and hold blade at right angles to arm. Pinch the end of the plastic clip located at the back of the arm.
Slide the wiper blade along the arm to release it from the hook.
Install new blade in reverse order to removing and make sure that it is properly attached to the wiper arm.
For reasons of safety, you should change the windshield wiper blades as soon as they start to leave marks on the windshield or fail to wipe efficiently and cleanly.
To obtain maximum lifetime from a set of wiper blades, clean them with a stiff- bristle brush and warm, soapy water as part of a normal car wash.
file:///K/ownersdocs/1992/1992_240/92240_094.htm (7 of 10)12/30/2006 9:31:35 AM
