Vornado 530L, 630B manual Features and Benefits, Installing Protective Feet, Assembly

Features and Benefits Assembly

Feature

Multiple Speeds

Benefit

With multiple speeds, any circulation need will be met. To turn on unit - rotate knob one position clockwise. Turn the knob clockwise to decrease airflow. Turn coun- terclockwise to increase airflow. On models equipped with push button speed controls: Press Power, then select speed.

Provides movement of air at any angle–up stairs, down a hallway, room to room and everywhere in between.

Installing Protective Feet

Use the feet to protect floors when using your air circulator on uncarpeted surfaces such as hardwood, vinyl, or tile. The feet are simple to install and will help maintain the whisper-quiet operation.

				Cushion Ring Feet
		²		(Models 723, 745, 783 and 795 only)
			²	The cushion ring feet are packaged separately
				in the box. To install, roll or clip all feet onto the
²
	²			base and space evenly. For balanced support it
				is recommended to use 4 ring feet.

Directable Airflow

Models V102, 270, 573, 673 and 679 provide movement of air in two positions - vertically or horizontally.

²	²	²
		²
²
²
²
²

Cushion Pads

(Model 733 and 735 only)

Use guide marks on base bottom for location.

1.Place 4 pads over the 4 edge bends.

2.Place 2 pads on each of the curved ends.

72

Energy Savings

Adjustable Height

Saves energy by maximizing the performance of heating and cooling systems. When you use a Vornado Air Circulator, you will not have to set your summertime thermostat as low or your wintertime thermostat as high.

(Model 783 and 795 only)

28” or 40” heights make this model perfect for out- of- the-way placement behind furniture and office fur- nishings. The extension tube must be used to achieve the 40” height. To shorten the height of the circulator, remove the extension tube. (See the Adjustable Height assembly instructions in the shipping carton.)

	Base Assembly
	(Model 743 only)
	1.	Align the pins (A) located on each base
		piece and insert into the holes (B) on each
B		base piece.
A	2.	Align and insert pivot knob (C) into hole
		located on the base (D).

3.Place rubber washer (E) onto pivot knob.

F		D	C	Then screw pivot knob into the head of unit
				(F) until secure. Repeat on opposite side of
				the base.
	E

English 7