Tools

You should gather the following tools before beginning installation. See throttle and cylinder supplements for any additional tools that may be needed for your application.

Tools

Power Drill

#1 Phillips screw driver

.125 (1/8) or 3.17 mm dia. drill

.469 (15/32) or 11.90 mm dia. drill Roll of masking tape

Rags

Knife

Pliers Silicone RTV

Loctite or similar product Electrical grease compound (Dow Corning #4)

Fig .4

Installation of The Electro-Hydraulic Unit

Please read the complete instructions thoroughly before starting your installation. If you have any questions call our Tech Support line. 1-800-588-7655

Locate the Electro-Hydraulic unit where it it will not be subjected to water submersion or spray from wash down.

Step one (Template)

Find the mounting template in your autopilot documentation package. Use the wall or floor section of the template as needed. Decide which screw type you need. Hold the template in the place with tape and drill right through it in the three indicated locations. See fig.5. Remove template and install screws in the indicated locations on template. Tighten these 2 screws down to 3/32” from the surface to allow enough space for the bracket on the pump to slide behind the screw.

Fig. 5

9

 

Page 9
Image 9
Garmin 906-2000-00 owner manual Tools, Installation of The Electro-Hydraulic Unit