ThrottleThrottleUp/Down
Increase throttle by pressing the Up Arrow button. Decrease throttle by pressing the Down Arrow button. The electric throttle runs in parallel with the tiller throttle, this means that you can't reduce the RPM with the electric throttle if the tiller throttle is set high. It is best to always run with the tiller throttle set to idle. Be careful to set the electric throttle and tiller throttle to closed position before starting your outboard.
Idle/Resume/ResumeFeature
Automatic idle and resume is accomplished by pressing the Idle/Resume button. If the throttle is set higher than idle, the Idle/ Resume function will take the engine to idle. If the throttle is sitting in the idle position, the Idle/Resume function will return the throttle to the last "above idle" position. The Idle/Resume button must be programmed to perform Idle/Resume and not MOB or Zigzags.
ChangeChangeHeadingHeadingUsingwithZigZigzZags-
If you program the Idle/Resume button for Zigzags (other), then when you press the Idle/Resume button the pilot will begin to zigzag about the heading you were on when you pressed the button. The zigzag angle and period are both programmable. An example zigzag path is shown in the figure below.
Heading Hold
Boat Path
27