Install the Back Box

The installation methods for the ICS090 Series include the following options:

Mount to the surface of a ceiling or wall

Install in a suspended ceiling

Install in a fixed ceiling or wall

Mount to the surface of a 4S standard electrical box

Install in a 4S deep electrical box

Select the best method for your installation and refer to the following pages for instructions.

INSTALLATION TO SURFACE OF A CEILING/WALL

Refer to Figure 2 for the following steps. Refer to Figure 3 if installing the unit to a concrete ceiling/wall.

1.Pull video and power wires through the ceiling/wall.

2.Connect the video cable/wires.

BNC: Connect the BNC connector from the Camclosure to a mating BNC connector.

Twisted pair: Connect the blue wire to Video +; connect the gray wire to Video -.

3.Connect the power wires.

Table A. Power Input: Surface of Ceiling/Wall Installation

Voltage

Red Wire

Black Wire

 

 

 

12 VDC

+

Ground

 

 

 

24 VAC

~

~

 

 

 

AC operation only: If you are wiring more than one ICS090 Camclosure to the same transformer, connect one side of the transformer to the red wire on all units, and then connect the other side of the transformer to the black wire on all units. Failure to connect all of the units in the same way will cause the cameras to be out of phase with each other, which might produce a vertical roll when switching between cameras.

8

C2462M-D (3/08)

Page 8
Image 8
Pelco 90 manual Install the Back Box, Installation to Surface of a CEILING/WALL, Voltage Red Wire Black Wire