Vornado DVTH Dvth Operating Controls, Resetting Your Vornado Heater, 1POWER ON/OFF 2COOLER, 4MODE

DVTH OPERATING CONTROLS

RESETTING YOUR VORNADO HEATER

2

3

4

1

1POWER ON/OFF

2COOLER

Lower the desired room temperature.

3WARMER

Raise the desired room temperature.

4MODE

HIGH HEAT 1500 watts, LOW HEAT 750 watts, or FAN ONLY.

5LCD DISPLAY

Indicates mode, room temperature or set temperature.

Your Vornado Heater has a multi-level safety shut-off system designed to prevent overheating. Overheating may occur when the inlets or outlet are blocked, a foreign object prevents the blade from turning, or the appliance tips over. If this happens, the safety shut-off system will cut power to the heat element and you will need to manually reset the heater.

1.	Set the POWER switch to OFF and unplug the unit.
2.	Remove any obstructions.
3.	Wait 5 –10 minutes, allowing the unit to cool down.
4.	Plug in the unit and place in desired position.
5.	Set the POWER switch to ON. Your Vornado Heater should now
	function normally.
	If the safety shut-off system repeatedly shuts off your heater or if it

6MODE light

Indicates the display is showing the current mode. FA is fan only. LO is low heat. Low heat is helpful for limiting the power draw on the circuit the unit is using. HI is high heat, for maximum heat potential. The unit will throttle back and draw only the power it needs to maintain the set temperature.

7ROOM TEMP light

Indicates the display is showing the current room temperature. The temperature is approximate and may vary based on room size and ceiling height.

8SET TEMP light

Indicates the display is showing the current desired room temperature. Note the set temperature can be changed just by pressing the WARMER or COOLER button; you do not need to press the MODE button first.

6 English

will not reset after following the above procedure, DO NOT

ATTEMPT TO DISASSEMBLE THE UNIT. Call Vornado Consumer

Services Department toll-free at 1-800-234-0604.