4
Getting started
Replace a handset
If you want to replace a handset or re-assign the designated hand set number
of a registered handset, you must de-register all the handsets an d then
individually register each handset.
To make de-registration easier, read all of the instructions on this page before
you begin. To de-register all handsets:
Press and hold FIND HANDSET on the telephon e base for about 10
seconds (until the IN USE light on the telephone base turns o n and starts to
ash), then release FIND HANDSET.
Press and release FIND HANDSET again. You must press FIND HAN DSET
while the IN USE light is still ashing. The IN USE li ght ashes for
approximately seven seconds.
All system handsets show CONNECTING.. . The de-registration process
takes about 10 seconds to complete. All handsets show NOT REGISTERE D
when the de-registration completes.
If de-registration fails, you might need to reset the telephone a nd try again.
To reset:
Pick up the registered handset and then press /FLASH.
Press OFF/CLEAR and place the handset back in the telepho ne base.
-OR-
Unplug the power from the telephone base, then plug it back in.
1.
2.
3.
1.
2.
1.
You cannot de-register a handset if any system handset i s in use.