Setup
Check for Dial Tone
After the battery is charged, connect the modular telephone cord between a live phone jack and the jack located on the bottom of the base unit. Pick up the handset and press ON. You should hear a dial tone.
CAUTION: Use only the VTech power supply provided with your telephone.
IMPORTANT! FOR MAXIMUM PERFORMANCE OF
YOUR CORDLESS TELEPHONE SYSTEM:
1. Choose a central location for your base unit.
2. Install your base unit and extension handsets away from electronic equipment, such as personal computers, television sets and microwave ovens.
3. In locations where there are multiple cordless telephones, separate base unit as much as pos- sible.
4.Install your telephone equipment away from heat sources and sunlight.
5.Avoid excessive moisture, dust or extreme cold.
Removable Handset and Base Plates
Your gz 2334 comes with additional handset and base plates of various colors. You can interchange these plates to suit your mood or room decor.
Handset Plate
Carefully remove the handset face and/or |
|
|
back plate by pressing the button on the top of |
|
|
the handset, then pulling the plate off. Attach |
|
|
the new face and/or back plate by snapping |
|
|
the lower portion, then the upper portion into |
|
|
position. |
|
|
NOTE: Ensure the bottom portion of the hand- |
|
|
set back cover is set into handset before |
|
|
snapping upper portion of cover into place. | Remove |
Base Plate
Carefully remove the base plate by pressing the button on the right side of the base unit, then pulling the plate off. Align the new base plate, making sure the antenna passes through the appropriate slot. Secure the plate by snapping it into position.
Remove |
Getting Started
5
