Windsor RRB 360 Troubleshooting, Error code, Fault, Remedy, Significance, service, battery charge

Troubleshooting

￿Danger

Risk of injury! Before carrying out any tasks on the machine, set the main key to "0" and remove it. Press emergency-stop button.

Fault	Remedy
Appliance cannot be started	Sit on the driver seat, the seat contact switch gets activated
	Release emergency-stop button
	Insert battery plug.
	Set main switch to “1”
	Check fuse F1, have it replaced by Windsor customer service if required
	Check battery; charge it, if needed
	Inform Windsor Customer Service.
Machine is not sweeping properly	Check roller brush and side brushes for wear, replace if necessary.
	Check function of bulk waste flap
	Check sealing strips for wear, adjust or replace as required
	Check belts of sweeping drive.
	Inform Windsor Customer Service.
Dust gathers in the machine	Empty waste container
	Check suction fan drive belt
	Check sealing cover on suction fan
	Check hoses of suction blower for absence of leakness.
	Check dust filter, clean or replace
	Check filter case seal
	Close wet/dry flap
	Check sealing strips for wear, adjust or replace as required
	Inform Windsor Customer Service.
Poor cleaning performance at edg-	Replace side brush
es	Check sealing strips for wear, adjust or replace as required
	Inform Windsor Customer Service.
Side brush or roller brush is not be-	Check fuse F2, replace if required.
ing lowered
	Inform Windsor Customer Service.
Insufficient vacuum performance	Check filter case seal
	Check sealing cover on suction fan
	Check hoses of suction blower for absence of leakness.
	Insert lamella filter correct; see Changing dust filter
	Inform Windsor Customer Service.
Roller brush does not turn.	Remove belts or cords from roller brush
	Inform Windsor Customer Service.
Error code is displayed.	Completely switch of the appliance and turn it back on.
	If this error recurs, please contact the Windsor customer service department

Error code

Indicator lamp -	Indicator lamp -	Indicator lamp -	Indicator lamp -	Indicator lamp -	Significance
service	battery charge	Overload of the	overlaod of the	Overload of the
	status indicator	filter cleaning	drive motor	sweep roller
yellow	green/yellow/red	red	red	red
blinking	--	--	--	x	Press emergency-stop button.
blinking	--	--	x	--	Overtemperature on the circuit board
blinking	--	--	x	x	Battery voltage defective
blinking	--	x	--	--	Drive pedal error
blinking	--	x	--	x	Line interruption, electrical consumers
blinking	--	x	x	--	Short circuit, electrical consumers
blinking	--	x	x	x	Error while charging
blinking	x	--	--	--	Performance module defective
blinking	x	--	--	x	Built-in charging device defective
blinking	x	--	x	--	General contactor does not open
Off	Not important	x	--	--	Overload of the filter cleaning
Off	Not important	--	x	--	Overlaod of the drive motor
Off	Not important	--	--	x	Overlaod of the sweep roller

English 17