Note
Press the
To unload the machine, proceed as follows:
ÎCut plastic packing belt and remove foil.
ÎRemove the elastic tape fasteners at the stop points.
ÎFour indicated floor boards of the pallet are fastened with screws. Unscrew these boards.
ÎPlace the boards on the edge of the pal- let. Place the boards in such a way that they lie in front of the four wheels of the machine. Fasten the boards with screws.
ÎSlide the four support beams included in the packaging under the ramp.
ÎRemove the wooden blocks used for ar- resting the wheels and slide them under the ramp.
(1)Machine without
Î Loosen immobilizing brake (see "move sweep machine").
Î Slide the machine over the prepared ramp from the pallet.
(2)Machine with
ÎConnect battery (see section on Care and maintenance)
ÎRelease
ÎSet main switch to "1".
ÎPress the drive direction switch and slowly move the machine down from the ramp.
ÎSet main switch back to "0".
Move the sweep machine
Danger
–Risk of injury! Before releasing the im- mobilizing brake, the machine must be secured to prevent it rolling away. After releasing the emergency brake, the ap- pliance will roll until a speed of 2.8 mph (4.5 km/h) is reached. After that, the electronics will brake the appliance.
–It is prohibited to release the emergen- cy brake on an incline without using the stopper.
ÎRemove the brake level from the wheel and put it in its position.
The immobilizing brake is thus deactivated; the machine can now be moved.
Start up
General notes
The appliance will brake electrically while standing still, if one of the following condi- tions is met.
–Foot was removed from the pedal.
–Operator's seat was left for more than 1 second.
–Key switch was set to “0”.
The automatic emergency brake will only work while the appliance is at a standstill.
ÎPark the sweeper on an even surface.
ÎRemove the key.
Inspection and maintenance work
ÎCheck charging status of battery.
ÎCheck side brush.
ÎCheck roller brush.
ÎShake off dust filter.
ÎEmpty waste container.
ÎCheck tyre pressure.
Note
For description, see section on Care and maintenance.
Operation
Adjusting driver's seat
ÎPull seat adjustment lever inwards.
ÎSlide seat, release lever and lock in place.
ÎCheck that the seat is properly locked in position by attempting to move it back- wards and forwards.
Check charging status of battery
–Indicator lamp glows green Battery is charged (100...40%).
–Indicator lamp glows yellow Battery is discharged to 40 ... 20%.
–Indicator lamp blinks red
Battery is almost discharged. The sweep- ing mode will be shortly switched off auto- matically.
–Indicator lamp glows red
Battery is discharged. The sweeping mode will be terminated automatically (the sweeping aggregates cannot be taken into operation until the battery is charged).
ÎDrive the machine directly to the charg- ing station; avoid any steep gradients in the process.
ÎCharge battery.
Check immobilizing brake
Danger
Danger of accident. The immobilizing brake must always be checked first on an even surface before starting the machine.
ÎTake the seating position.
ÎRelease
ÎSet main switch to "1".
ÎActivate the travel direction switch (for- ward/reverse).
ÎGently depress drive pedal.
ÎYou must hear the brake being re- leased. The machine must roll slightly on a plane surface. When the pedal is released, the brake falls in in an audible manner. Switch off the machine and call the aftersales service if the
Storage area
Note
The max. load of the storage area is 44.1 lbs (20 kg).
ÎFasten the load through appropriate fasteners at the 4 eyelets.
Emergency-stop button
–The appliance has an emergency OFF switch. If this switch is pressed, the ap- pliance will stop abruptly and the auto- matic emergency brake will be activated.
–In order to restart the appliance, first un- lock the emergency OFF switch, then turn the key switch on and off.
Programme selection
1Driving
Driving to the Place of Use.
2Sweeping with sweep roller
Roller brush is lowered. The roller brush and the side brush will rotate.
3Sweeping using roller brush and side brushes
Roller brush and side brushes are low- ered.
Turning on the Machine
Note
The machine is equipped with a seat con- tact switch When you quit the driver seat, the machine comes to a halt after a delay of approx. 1.5 seconds and the activated sweep function is switched off.
ÎSit on the driver's seat.
English 11
